Abstract

This research reveals the applied engineering basis for determining the particle size and settling velocity distributions of solids generated while rearing wild-caught premature punctuated snake-eels (Ophichthus remiger) in a prototype recirculating aquacultural system. Settled solids were sampled from the bottom of the rearing tanks, and suspended solids were sampled before filtration within the drum filter and analyzed to characterize their settling velocity and particle size properties. These particle properties are considered bioengineering parameters since they will provide biological information to improve engineering solutions for RAS solids removal processes. The average settling velocity for the settleable solids in the rearing tanks was 2.89 +/- 0.02 cm s(-1) , and the average particle size ranged between 7.32 +/- 3.41 and 19.44 +/- 8.58 mm. Suspended solids within the drum filters before filtration had an average settling velocity of 0.35 +/- 0.11 cm s(-1) and it was found that 69.93 % of the particles size was greater than 200 mu m, 15.40 % were within the range of 120 mu m and 90 mu m sizes, and 6.53 % were between 70 mu m and 40 mu m sizes. The particle physical properties, settling curves, and particle sizes curves obtained from this experience represent valuable information to be used to improve engineering design of solids handling mechanisms, especially in marine land-based systems, and in this case, applied for rearing wild-caught punctuated snake-eels. The present investigation constitutes an advance in the knowledge of applied engineering to the design of a marine aquaculture fattening operation targeted to feed up wild-caught premature punctuated snake-eels to the point of sale or trade.