Abstract

Lattice structures produced by additive manufacturing are increasingly used in lightweight, load-bearing applications, yet their mechanical performance is strongly influenced by geometry, process parameters, and boundary conditions. This study investigates the compressive behavior of body-centered cubic (BCC) 316L stainless steel lattices fabricated by laser powder bed fusion (LPBF). Four relative densities (20%, 40%, 60%, and 80%) were achieved by varying the strut diameter, and specimens were built in both vertical and horizontal orientations. Quasi-static compression tests characterized the elastic modulus, yield strength, energy absorption, and mean force, while finite element simulations reproduced the deformation and hardening behavior. The experimental results showed a direct correlation between density and mechanical properties, with vertically built specimens performing slightly better due to reduced processing defects. Simulations quantified the effect of strut–joint rounding and the need for multi-cell configurations to closely match the experimental curves. Regardless of the boundary conditions, for a density of 20%, simulating a single cell underestimated stiffness because of unconstrained strut buckling. For higher densities and thicker struts, this sensitivity to boundary conditions strongly decreased, indicating the possibility of using a single cell for shorter simulations—a point rarely discussed in the literature. Both experiments and simulations confirmed Gibson–Ashby scaling for elastic modulus and yield strength, while the tangent modulus was highly sensitive to boundary conditions. The combined experimental and numerical results provide a framework for the reliable modeling and design of metallic lattices for energy absorption, biomedical, and lightweight structural applications. © 2025 by the authors.