Man

Rodrigo Sebastian Barraza Vicencio

Professor

Universidad Técnica Federico Santa Maria

Santiago, Chile

Líneas de Investigación


Energy conversion, Heat and mass transfer; Solar Energy, Multiphase Flow;

Educación

  •  Master of Science (M.S) in Mechanical Engineering, UNIVERSITY OF WISCONSIN-MADISON. Estados Unidos, 2011
  •  Doctor of Philosophy (Ph.D) in Mechanical Engineering, UNIVERSITY OF WISCONSIN-MADISON. Estados Unidos, 2015
  •  Ingeniero Civil Mecánico, UNIVERSIDAD TECNICA FEDERICO SANTA MARIA. Chile, 2005

Experiencia Académica

  •   Profesor Auxiliar Full Time

    UNIVERSIDAD TECNICA FEDERICO SANTA MARIA

    Chile

    2014 - A la fecha

Experiencia Profesional

  •   Jefe de proyecto Full Time

    Gamma Ingenieros S.A.

    Santiago, Chile

    2005 - 2010


 

Article (37)

Application of layer view factor method in high temperature thermal storage packed bed
Electrical Model Analysis for Bifacial PV Modules Using Real Performance Data in Laboratory
Sensitivity Analysis of Peer-to-peer Photovoltaic Energy Trading in a Community Microgrid in Chile
Transient modeling of stratified thermal storage tanks: Comparison of 1D models and the Advanced Flowrate Distribution method
"An enhanced and optimized Monte Carlo method to calculate view factors in packed beds"
Estimation of the impact of natural soiling on solar module operation through image analysis
A discrete element approach to model packed bed thermal storage
Analysis of the influence of the position of the reflective layer on the thermal performance of a multi-layer lightweight wall panel
Automatic soiling and partial shading assessment on PV modules through RGB images analysis
Bond calibration method for macroparameters using the discrete element method framework
Economic evaluation of fuel cell-powered OFF-ROAD machinery using stochastic analysis
Transient simulation of a control strategy for solar receivers based on mass flow valves adjustments and heliostats aiming
Tuning Analysis and Optimization of a Cluster-Based Aiming Methodology for Solar Central Receivers
A self-tunable wind energy harvester utilising a piezoelectric cantilever beam with bluff body under transverse galloping for field deployment
Assessing the use of copper slags as thermal energy storage material for packed-bed systems
Development and Implementation of an Anthropomorphic Underactuated Prosthesis with Adaptive Grip
Estimation of Single-Diode Photovoltaic Model Using the Differential Evolution Algorithm with Adaptive Boundaries
Experimental test and sensitivity analysis of performance parameters of a solar humidification-dehumidification system
Optimal design and experimental test of a solar simulator for solar photovoltaic modules
Optimized operation of recompression sCO2 Brayton cycle based on adjustable recompression fraction under variable conditions
Parametric analysis of an air-based radiative cooling system coupled to a thermal storage wall for a low-income household
Review on modeling approaches for packed-bed thermal storage systems
Techno-economic optimization of coupling a cascaded MED system to a CSP-sCO<sub>2</sub> power plant
Thermo-structural analysis of a honeycomb-type volumetric absorber for concentrated solar power applications
Aiming clusters of heliostats over solar receivers for distributing heat flux using one variable per group
Assessment of a Compressed Air Energy Storage System using gas pipelines as storage devices in Chile
Comprehensive model for the analysis of feasibility of the use of Thermoactive Building systems in office buildings in Chile
Potential Map for the Installation of Concentrated Solar Power Towers in Chile
Computational analysis for a multi-effect distillation (MED) plant driven by solar energy in Chile
Design and Simulation of an Energy Homeostaticity System for Electric and Thermal Power Management in a Building with Smart Microgrid
A Cost-Effective Methodology for Sizing Solar PV Systems for Existing Irrigation Facilities in Chile
Parametrized analysis of a carbon dioxide transcritical Rankine cycle driven by solar energy
A numerical model for boiling heat transfer coefficient of zeotropic mixtures
Experimental facility to measure heat transfer and pressure drop of boiling zeotropic multi-component mixtures in a horizontal tube
Measured and predicted frictional pressure drop for boiling zeotropic mixed refrigerants in horizontal tubes
Measured and predicted heat transfer coefficients for boiling zeotropic mixed refrigerants in horizontal tubes
Measurements of convection heat transfer coefficients for hydrocarbon mixtures during boiling in a heated horizontal pipe from 100 K to room temperature

BookSection (1)

Desafios y oportunidades para la energia solar en el Chile actual

ConferencePaper (4)

Experimental and numerical evaluation of a humidification dehumidification desalination unit driven by solar energy
Dynamic model of supercritical CO2 brayton cycles driven by concentrated solar power
Heat flux distribution over a solar central receiver using an aiming strategy based on a conventional closed control loop
Description and validation of the Little correlation for boiling zeotropic mixtures in horizontal tubes from cryogenic to room temperature

Proyecto (8)

High Temperature termal storage for concentrated solar power plants using a packed bed of rocks
Sistema multisensorial de detección temprana de descargas superficiales en aisladores de equipos primarios
“Solar Energy Research Center“-SERC-Chile
Desaladora Solar HDH
Evaluación de prefactibilidad de desarrollo de proyecto de acumulación de aire comprimido para generación de energía (CAES).
Sistema autónomo de mantenimiento basado en condición (CBM) para plantas fotovoltaicas en climas desérticos y de alta radiación.
Diseño y Construcción de una planta de desalinización solar
Development of a computational model to predict heat transfer coefficients of boiling zeotropic mixtures in small horizontal tubes (Modelamiento computacional de la evaporación convectiva de mezclas refrigerantes en tuberías horizontales).
1
Mauricio Osses

Académico

Ingenieria Mecanica

Universidad Tecnica Federico Santa Maria

Santiago, Chile

1
Williams Calderón

Profesor Asociado

Ingeniería Mecánica

UNIVERSIDAD DE CHILE, FACULTAD DE CIENCIAS FISICAS Y MATEMATICAS, DEPARTAMENTO DE INGENIERIA MECANICA

Santiago, Chile

3
Jose Cardemil

Profesor Asociado

Ingeniería Mecánica y Metalúrgica

Pontificia Universidad Católica de Chile

Santiago, Chile

11
PATRICIO VALDIVIA

Associate Professor

Ingenieria Electrica

universidad de san

Santiago, Chile

44
Rodrigo Barraza

Professor

Mechanical Engineering

Universidad Técnica Federico Santa Maria

Santiago, Chile

2
Jorge Ardila

Profesor Auxiliar

UNIVERSIDAD TECNICA FEDERICO SANTA MARIA

santiago de chile, ñuñoa, Chile

4
Antonio Sánchez

Profesor Auxiliar

Ingeniería Eléctrica

UNIVERSIDAD TECNICA FEDERICO SANTA MARIA

Santiago, Chile

1
Fernando Yanine

Academico de Planta Full Time, Investigador

Facultad de Ingeniería

Universidad Finis Terrae

Santiago, Chile

1
Nina Hormazabal

Profesor Asociado

Arquitectura

Universidad Técnica Federico Santa María

Valparaíso, Chile

1
Lorena Cornejo

Coordinadora de Ciencia y Sociedad

SERC Chile, Universidad de Chile

Santiago, Chile

1
Masoud Behzad

Assistant professor

Universidad Diego Portales

Santiago, Chile

2
Jesus Garcia

Académico

Ingeniería Mecánica

Universidad Austral de Chile

Valdivia, Chile

1
Benjamín Herrmann

Profesor Asistente

Departamento de Ingeniería Mecánica

Universidad de Chile

Santiago, Chile

2
Catalina Hernández

Ingeniero Investigador

Sistemas Solares Térmicos

Fraunhofer Chile Research

SANTIAGO CENTRO, Chile

1
Matías Cerda

Asistente Científico

Departamento de ingeniería eléctrica

Universidad Técnica Federico Santa María

Santiago, Chile

2
Cristóbal Sarmiento

Académico de Jornada Completa

Facultad de Ingeniería y Ciencias

Universidad Diego Portales

Santiago, Chile

1
Ignacio Calderón

Estudiante de Doctorado

Departamento de Ingeniería Mecánica y Metalúrgica

Pontificia Universidad Católica de Chile

Santiago, Chile

1
Valentina Segovia

Tesista de Doctorado

Departamento de Ingeniería Mecánica y Metalúrgica

Pontificia Universidad Católica de Chile

Santiago, Chile

1
leonardo gacitua

Académico

Ingeniería eléctrica

Universidad Técnica Federico Santa María

Santiago, Chile

2
Carlos Cárdenas

Proffesor

Electrical Engineering

Universidad Técnica Federico Santa María

Santiago, Chile